Description
Features :
- The P12 PWM PST is a 120 mm fan with PWM PST connectors. It features Completely redesigned fan blades and is optimized for high static pressure.
- Thanks to this, it is especially effective when used on heatsinks and in situations with higher air resistance.
- The wide RPM range from 200 to 1800 RPM can be regulated seamlessly and synchronously with other fans thanks to ARCTIC PWM Sharing Technology (PST).
- The newly developed motor with a low coil temperature significantly increases the life span of the fan.
Optimized for static pressure
during the development of the new P12 PWM PST, special emphasis was placed on a focused airstream and thus a high static pressure. The fan guarantees extremely efficient cooling, even with increased air resistance. Therefore, the P12 PWM PST is particularly suitable for use on heatsinks and radiators.
more efficient technology
the motor is powered by a neodym-iron-boron-magnet Ring of the newest generation, which allows the new P12 PWM PST to run much more Efficiently than its predecessors. This saves energy and lowers the coil temperature without compromising the performance.
maximum quietness, minimum vibration
even at low speeds The operating sound of the new ARCTIC motor is barely noticeable. Due to a sinus-magnetizing the new motor only creates about 5% of the commutator oscillations of a regular dc-motor. Consequently, there is no need for rubber spacers Due to the steady and smooth torque of the new motor.
extended life span
a 10 °C lower motor temperature roughly doubles the life span of a fan. The new ARCTIC motor has a four times longer service life through its low coil temperature. Consequently, we have extended the warranty to 10 years.
200 to 1800 RPM regulated via PWM pst
thanks to the 4-pin connector, The RPM can be regulated in a broad spectrum via PWM. In this way, noise is kept at a minimum while maximum cooling performance is guaranteed when needed.
0 db mode
the P12 PWM PST is able to switch into silent passive mode when PWM signal is below 5 % Due to its new motor. This allows working at your PC in complete silence without any unwanted noise.
high quality bearing
thanks to an alloy/lubricant combination developed In Germany, friction within the bearing is reduced and greater efficiency is achieved. As a result, there is less heat Development as well as less bearing noise.
